Simpson Strong-Tie CNW3/4 3/4-Inch Coupler Nut With Witness Hole 80 Pk

Simpson Strong-Tie CNW3/4 3/4-Inch Coupler Nut With Witness Hole 80 Pk

by:

$230.48

SKU: Simpson-CNW3/4-80

Simpson-CNW3/4-80
GTIN: 10044315483209
- Free Shipping -
Simpson-CNW3/4-80

Simpson Strong-Tie coupler nuts are a tested and load-rated method to join threaded rod and anchor bolts. The Witness® hole in each nut provides a means to verify when rods are properly installed. The positive stop feature helps ensure even threading into each end of the nut. The CNW exceeds the specified minimum tensile capacity of corresponding ASTM A36 bolts and threaded rod. The HSCNW exceeds the specified minimum tensile capacity of corresponding ASTM A449 bolts and threaded rod. Contact Simpson Strong-Tie for other coupler nut sizes.

Finish

  • Zinc plated

Installation

  • Tighten the two rods until each all-thread rod is visible in the Witness hole. Any portion of thread visible in the Witness hole is a correct installation.
  • Standard CNW for use with non-hot-dip galvanized all-thread rod only.
  • 5/8"- and 7/8"-diameter couplers available with oversized threads for installation to hot-dip galvanized bolts (order CNW5/8-5/8OST and CNW7/8-7/8OST).
  • Some OST couplers are typically oversized on one end of the coupler nut only and will be marked with an "O" on oversized side. Couplers may be special ordered with both ends oversized. Contact Simpson Strong-Tie to order.

Please Note: This product image may represent a range of products; it may not be an exact representation of the product purchased.

 

 

By Manufacturer

Recommended Products